Publicidad
Idiomas disponibles
Idiomas disponibles
Overdischarge protection
When the battery capacity is not enough, the tool stops automatically. In this case, remove the battery from
the tool and charge the battery.
Switch action
1. Switch trigger
CAUTION:
Before installing the battery cartridge into the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
Lighting up the front lamp
1. Work Lamp
CAUTION:
Do not look in the light or see the source of light directly.
NOTE: Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination
1
1
To start the tool, simply pull
the switch trigger. Tool speed
is increased by increasing
pressure on the switch
trigger. Release the switch
trigger to stop.
Pull the switch trigger to light
up the lamp. The lamp
keeps on lighting while the
switch trigger is being pulled.
The lamp goes out
immediately after releasing
the switch trigger.
Keep Working
10
Publicidad
