Publicidad
Idiomas disponibles
Idiomas disponibles
Procedure 1
For tool without one-touch type sleeve
1. Driver bit
2. Sleeve
3. Socket bolt
To install the driver bit or socket bolt, pull the sleeve in the direction of the arrow and insert the driver bit or
socket bolt into the sleeve as far as it will go.
Then release the sleeve to secure the driver bit.
To remove the driver bit or socket bolt, perform the installation procedure in reverse.
NOTE: If the driver bit is not inserted deep enough into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this case, try re-inserting the bit according to the instruc-
tions above.
NOTE: When it is difficult to insert the driver bit, pull the sleeve and insert it into the sleeve as far as it will go.
NOTE: After inserting the driver bit, make sure that it is firmly secured. If it comes out, do not use it.
Installing hook
CAUTION:
When installing the hook, always secure it with the screw firmly. If not, the hook may come off
from the tool and result in the personal injury.
2
3
1. Groove
2. Hook
3. Screw
1
2
1
3
The hook is convenient for temporarily
hanging the tool. This can be installed
on both side of the tool. To install the
hook, insert it into a groove in the tool
housing on either side and then secure
it with a screw. To remove, loosen the
screw and then take it out
Keep Working
12
Publicidad
