Cherubini WAVE LOCK RX Instrucciones página 37

DEACTIVATION OF THE COUPLING FUNCTION
To deactivate this function:
a - Put the awning to its half-way point
b - Perform the command sequence as described:
+
B C
Tn
c - The automatic coupling and uncoupling movements are now deactivated. By pressing
the down key, the awning will stop in the "lowest coupling limit" position.
The coupling and uncoupling positions are not deleted. They may be reactivated at any
time, without to set again the positions.
ACTIVATION OF THE COUPLING FUNCTION
To activate the function:
a - Put the awning to its half-way point
b - Perform the command sequence as described:
Tn: Already programmed remote control
+
B C
Tn
The motor may be used on an awning without using the coupling/uncoupling device even
if available on the Pergola. In this case, the coupling and uncoupling positions should
both be set to avoid coupling. After setting the limit switches, the automatic coupling and
uncoupling function must be deactivated.
If the limit switches are already set, follow this procedure:
b - Delete and set again the lower limit switch on a different position to avoid the coupling.
For this purpose the "lowest coupling limit" position and the "lowest uncoupling
limit" position may be programmed in approximately the same position.
c - Deactivating the coupling function.
+
B C
+
B C
USING THE MOTOR WITHOUT THE
COUPLING/UNCOUPLING DEVICE
Tn
Tn
37
A
Tn (2 sec)
B
Tn (2 sec)