YATO YT-828135 Instrucciones Originales página 14

PRODUCT OVERVIEW
The chainsaw is only intended for cutting wood. The chainsaw electric drive allows it to be used under a canopy or near buildings.
Thanks to the battery power supply, the chainsaw allows you to work in places where mains-powered products could not be used.
The saw is used to cut branches, and trim shrubs and bushes. The power saw is not designed to fell trees. Proper, reliable and
safe operation of the tool depends on appropriate use, that is why you should
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the tool, failure to observe the safety
regulations and recommendations of this manual. Use of the tool for purposes other than those for which it was intended shall
cause the loss of the user's rights to a warranty and statutory warranty.
PRODUCT EQUIPMENT
The power saw is supplied complete but requires assembly before fi rst use. The following elements are supplied with the power
saw: a chain guide bar, a cutting chain and a guard for the guide bar with chain. The battery and charging station (charger) are
only provided with the YT-828135 product. The YT-828136 product is not provided with a battery and charger.
TECHNICAL DATA
Parameter
Catalogue No.
Rated voltage
Chain speed
Guide bar length
Chain scale
Number of chain drive wheel teeth and scale
Guide slot width
Protection class
Weight (without the battery, guide bar and chain)
Noise level
- L (pressure)
pA
- L (power)
wA
Vibration a (front handle, rear handle)
h
Battery type
Battery capacity*
Battery energy
Charger*
Input voltage
Mains frequency
Rated power
Output voltage
Output current
Charging time**
* only for models equipped with a battery and charger
** the specifi ed charging time applies only to the battery with the capacity listed in the table
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is
used.
Caution! Safety measures to protect the operator, which are based on an exposure assessment under actual conditions of use
(including all parts of the work cycle, such as the time when the tool is turned off or idle and the activation time), must be specifi ed.
O R I G I N A L
14
EN
Unit
[V]
[m/s]
[mm / '']
[mm / '']
[mm / '']
[kg]
[dB] (A)
[dB] (A)
[m/s ]
2
[Ah]
[Wh]
[V~]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-828135, YT-828136
18 d.c.
4,8
101 / 4
7,62 / 0.3
6 teeth x 7,62 mm
1.1 / 0.043
III
1.1
78.0 ± 3.0
89.0 ± 3,0
3.425 ± 1.5
Li-ION
2
36
220 – 240
50 / 60
60
21 D.C.
2.4
1