- THESE SAFETY REGULATIONS INTEGRATE OR COM-
PLEMENT THE LOCAL SAFETY REGULATIONS.
- NEVER carry out hasty or makeshift repairs which could
jeopardize the oven functioning and user's safety, as
well.
- IN CASE OF DOUBT ALWAYS ASK FOR THE PRESENCE
OF SKILLED PERSONNEL.
- MANUFACTURER DISCLAIMS ALL RESPONSIBILITY
IN CASE OF ELECTRIC, ELECTRONIC, MECHANICAL
TAMPERING OF THE OVEN BY USER OR CARELES-
SNESS OF USER BY USING IT.
1.2 - REFERENCE NORMATIVE
- The oven and its safety devices have been built ac-
cording to the rules being indicated in the declaration
of conformity.
1.3 - DESCRIPTION OF THE SYMBOLS
Several accidents are due to an insuffi cient know-
ledge and a lack of fulfi lment of safety rules to be
considered during functioning and maintenance of
the oven.
To avoid accidents, all warning notes and instruc-
tions contained in this handbook as well as the ones
being reported on the oven plates, shall be read,
understood and observed.
To identify the safety messages included in this bo-
oklet, following symbols have been used:
DANGER
This symbol is used in the safety messages con-
tained in the booklet in case of potential danger
situations or possibility to cause serious injuries
or dead.
GB - 4
General specifi cations and warning
ATTENTION
This symbol is used in the safety messages of the
booklet for any danger situation that, if disregarded,
may cause small or moderate injuries or damages.
The message can also be used as to dangers which
can damage the oven.
IMPORTANT
This symbol is utilized in order to avoid operations
which could result a shorter oven life or for important
messages to user.
For clearness purposes, some pictures in this
handbook show the oven without protection
structures. DO NOT USE THE OVEN WITHOUT
PROTECTION STRUCTURES.
1.4 - OVEN COMPOSITION
Manufacturer's ovens are the result of a several year-
experience.
•
Single-chamber, two-chamber or three-chamber
ovens with digital or manual functioning.
•
Over the oven, an extractor hood controlled by a
special board can be installed.
•
The oven/s are supported by a bearing base.
DOMITOR DM/DB
DANGER