Weber Spirit E/EP - 320 Guia Del Propietario página 15

PROBLEM
Side Burner burns with a yellow or
orange flame, in conjunction with the
smell of gas.
Side Burner does not light.
Flame is low in "HI" position.
Push button ignition does not work.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ® .
SIDE BURNER MAINTENANCE
WARNING: All gas controls and supply valves should be in
the "OFF" position.
Make sure black wire is connected between the igniter and electrode.
Make sure white wire is connected between the igniter and grounding clip.
Spark should be a white/blue color, not yellow.
1) Igniter Wire
2) Ground wire
3) Burner
Side Burner Grate
Side Burner Grate
Side Burner Cap
Side Burner cap
e Burner Ring & Head
Side Burner Ring & Head
Igniter Electrode
Igniter Electrode
WARNING: The side burner orifice (4)
must be parallel to the side burner tube
opening (5).
WWW.WEBER.COM
®
SIDEBURNER TROUBLESHOOTING
CHECK
Inspect side burner orifice alignment
(Position of orifice to side burner tube.)
Is gas supply off?
The excess flow safety device, which is part
of the barbecue to cylinder connection, may
have activated.
Is the fuel hose bent or kinked?
Does burner light with a match?
Control Knob
Control Knob
Igniter Button
Igniter
Loosen orifice and re-align orifice parallel to the side burner tube (3) .
(See Section "Side Burner Maintenance")
Turn supply on.
To reset the excess flow safety device turn all burner control knobs and the cylinder
valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to
START/HI. Wait at least 1 minute. Turn burner control knobs to "OFF" . Reconnect the
regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting Instructions" .
Straighten hose.
If match lights burner, check igniter (see Sideburner Maintenance).
(3)
(4)
(5)
15
CURE
(2)
(1)
(2)
(1)
15