Klarstein VINOVILLA DUO79 Manual Del Usuario página 33

1. To put the cabinet on open operation place, the door opened to the maximum angle.
2. Use small knife(2) to take off the decorative nail (1) on opposite side (Drawing 1)
3. Use the inner six angle screwdriver (Tool 5) to disassemble the screws(4) of drop-
proof device (3), then remove the drop-proof device .(Drawing 1)
4. Hold the door, use six angle screwdriver (Tool 5) to screw out the door shaft
core(6) from the two ends of the top of the door. Take out the door and set aside.
(Drawing 2)
5. Discharge the upper and lower door hinge(7)(8) by MS inner six angle screwdriver
(Tool 5) , then to assemble the door hinge on the opposite side. (Drawing 3 and 4 )
6. Rotate the door 180 degrees, then Install the door on the right side of the cabinet.
(Drawing 5)
7. Finally, install the decorative nail and drop-proof device at the opposite side.
(Drawing 6)
Handle Installation Method
1 Take out handle from cabinet, then
take out four pcs 4*35 screws from
accessory bag.
2 Pull open door seal from the side of
door, then insert screws into the 2
handle holes on side of door, then
put the screws alignment the hole
of handle , tighten the screws by
Phillips screwdriver then compress
the door seal
3 If the screws holes of the handle
don't match perfectly with the holes
of the door, please use the electric
drill to drill the holes of the door a
bit big (in surface side), in order to
install the handle perfectly.
Installation of the ventilation frame
Remove the ventilation frame from the packaging. Open the door, align the
ventilation frame with the four screw holes in the bottom of the cabinet and tighten the
four 4*12 screws with a screwdriver.
EN
33