Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
WARNING: Failure to position the parts in accordance with these diagrams or failure
to use only parts specifically approved with this gas fireplace insert may result in
property damage or personal injury.
Before beginning assembly or operation of the product, make sure all parts are present.
Compare parts with package contents list. If any part is missing or damaged, do not attempt
to assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 20 minutes
Tools Required for Assembly (Not Included, unless otherwise stated):
Before installing the gas fireplace insert, make sure you have the the following:
• Hardware package (provided with the gas fireplace insert)
• Approved flexible gas hose if allowed by local codes
• Sealant (resistant to natural gas)
• Electric drill with 3/16- in. drill bit
• Phillips screwdriver
• External regulator (supplied by installer if required)
• Piping (check local codes)
UNPACKING
1. Remove the burner base assembly from carton. NOTE: Do not pick up burner base
assembly by burners as this could damage the gas fireplace insert. Always handle base assembly
by the frame.
2. Remove all protective packaging applied for shipment.
3. Check all items for any shipping damage. If damaged, promptly inform dealer where you
purchased the gas fireplace insert.
INSTALLATION OF BATTERY
1. Rotate the base assembly upside down.
2. Turn the battery cover counter clockwise
until it comes off of the base assembly.
3. Slide in the AAA battery (provided)
4. Replace the battery cover by turning it
clockwise to tighten. Do not overtighten.
BATTERY INSTRUCTIONS
• Batteries are included.
• Remove batteries when depleted.
• Install/replace the batteries according to the type and quantity stated in table below.
• Be sure to observe proper polarity (+/-) when installing or replacing the batteries. Damage due to
improper battery installation may void the warranty on the product.
• For long periods of non-operation, remove batteries from all components for safety.
Component
Ignitor
Type of Battery
AAA
Fig. 11
Base Assembly
Battery Qty.
1
16
• Equipment shutoff valve
• Test gauge connection
• Sediment trap
• Tee joint
• Pipe wrench
• 3/8" NPT to 1/2" flare fitting
• Allen Wrench
AAA Battery
(+ side facing outward)
Battery Cover
Publicidad
