Powermate PFTT140 Manual De Operación página 9

Assembly
(Continued)
• Save all instructions
B
Assembly Instructions
The tiller comes fully assembled except for a few parts. The following instructions will help you complete the tiller assembly.
INSTALL THE WHEELS
(See Figure 2)
1. Slide the wheel hub onto the wheel axle.
2. Install M8 x 20 mm bolt with 30 mm flat washer.
3. Snap hubcap into place.
INSTALL THE DRAG BAR
1. Insert the drag bar into the bottom of the swing plate bracket.
2. Insert the pin thru the bracket and drag bar.
Questions? Call Toll Free at 1-800-737-2112
Figure 2
Figure 4a
(See Figure 4a and 4b)
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
Handle Knobs Handle Knobs
Saddle Bolts Saddle Bolts
ATTACH UPPER HANDLE
1. Slide the upper handle down over the lower handle and
align the holes.
2. Insert the saddle bolts into the holes as shown and
securely with the handle knobs.
3. Tighten the handle knobs securely.
INSTALL LOWER HANDLE
1. Install lower handle to frame using M10 x 25 bolts and
washers.
8
EN-8
Copyright © 2015 MAT Engine Technologies, LLC
Handle Knobs Handle Knobs
Saddle Bolts Saddle Bolts
Figure 3
(See Figure 3)
(See Figure 3)
Figure 4b