Resumen de contenidos para Sauder North Avenue 420277
Página 1
NOTE: THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR Need help? Visit Sauder.com to view video assembly tips or chat with a live rep. FUTURE REFERENCE. Prefer the phone? Call 1-800-445-1527. English pg 1-8 Français pg 9-10 Español pg 11-12...
Página 2
Assembly Tools Required Part Identifi cation No. 2 Phillips Screwdriver Tip Shown Actual Size Hardware Identifi cation Assembly Steps Rubber Mallet Français 9-10 Español 11-12 Electric drill with 1/4" bit (ONLY in indicated step) Safety 13-14 Warranty Page 2 www.sauder.com 420277...
Página 3
While not all parts are labeled, some of the parts will have a label or an inked letter on the edge to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts. TOP (1) UPPER SHELF (1) SHELF (3) UPPER END (2) LOWER END (2) SHELF SUPPORT (10) 420277 www.sauder.com Page 3...
Página 4
Screws are shown actual size. You may receive extra hardware with your unit. 1-3/8" ALLEN SCREW - 20 1/2" ALLEN SCREW - 8 1-1/8" SCREW - 20 ALLEN WRENCH - 1 FURNITURE TIPPING RESTRAINT KIT - 1 Page 4 www.sauder.com 420277...
Página 5
Look for this icon. It means a Step 1 video assembly tip is available at www.sauder.com/services/tips Assemble your unit on a carpeted fl oor or on the empty carton to avoid scratching your unit or the fl oor. å NOTE: You should start each SCREW a few turns before completely tightening any of them.
Página 6
Fasten the ENDS (D and E) to the SHELF SUPPORTS (F). Use twenty 1-3/8" ALLEN SCREWS (1) and the å ALLEN WRENCH (8). NOTE: Be sure to square up the SHELF SUPPORTS (F) to the ENDS (D and E) before you completely tighten å the SCREWS. 1-3/8" ALLEN SCREW (20 used in this step) Page 6 www.sauder.com 420277...
Página 7
NOTE: The TOP (A) is larger than the SHELVES (B and C). The UPPER SHELF (B) is fi nished on both sides. Be sure to å position these parts exactly as shown in the diagram below. NOTE: Do not overtighten the SCREWS. å 1-1/8" SCREW (20 used in this step) 420277 www.sauder.com Page 7...
Página 8
And to celebrate, why not share your success story? Use the 5/8" screw through the Small hole small hole in a bracket and into the back edge of the TOP (A). 25 lbs. 30 lbs. 30 lbs. 30 lbs. 30 lbs. Page 8 www.sauder.com 420277...
Página 9
élément et conserver le livret pour future référence. DESSUS ................1 VIS ALLEN 35 mm..........20 Pour contacter Sauder TABLETTE SUPÉRIEURE ........1 VIS 28 mm ..............20 en ce qui concerne cet TABLETTE .................3 VIS ALLEN 13 mm ............8 élément, faire référence...
Página 10
TABLETTES (B et C). La TABLETTE SUPÉRIEURE (B) est fi ni sur tous les côtés. S’ a ssurer de placer ces pièces exactement comme l’indiquent le schéma ci-dessous. REMARQUE : Ne pas trop serrer les VIS. Page 10 www.sauder.com 420277...
Página 11
TORNILLO ALLEN de 35 mm .......20 et conserver le livret pour future référence. ESTANTE SUPERIOR ............1 TORNILLO de 28 mm ..........20 Pour contacter Sauder ESTANTE ..................3 TORNILLO ALLEN de 13 mm ......8 en ce qui concerne cet EXTREMO SUPERIOR ............2 LLAVE ALLEN ..............1...
Página 12
NOTA: El PANEL SUPERIOR (A) esté más grande que los ESTANTES (B y C). El ESTANTE SUPERIOR (B) esté acabado en los dos lados. Asegúrese de posicionar estas partes exactamente como se muestra en el diagrama mas abajo. NOTA: No apriete los TORNILLOS en exceso. Page 12 www.sauder.com 420277...
Página 13
Les téléviseurs peuvent être un téléviseur. cet eff et. particulièrement lourds. De plus, le poids et l’emplacement du tube image ont tendance à rendre les téléviseurs instables et enclins à tomber vers l’ a vant. 420277 www.sauder.com Page 13...
Página 14
Además, el peso y la ubicación del tubo de imagen tienden a causar la inestabilidad de televisores y propensa a volcarse hacia adelante. Page 14 www.sauder.com 420277...
Página 15
à compter de la date d'achat la première fois et qui sont signalés à Sauder dans les limites de couverture de la contre tout défaut de matériaux ou de fabrication des composantes de mobilier Sauder.
Página 16
Dear Valued Customer: So, how did it go? Thanks so much for choosing Sauder® furniture. I hope the Set a world record for speed? purchase and assembly process was a positive experience Feeling good about yourself? and you feel good about the furniture you just built. If you Nice.