Publicidad
Idiomas disponibles
Idiomas disponibles
purpose. Contact local authorities or your provider
for recycling advice. Thank you for recycling at
the collection points provided for this manual.
Note: The important warnings and instructions
indicated in this manual are not guaranteed
to cover all possible conditions and situations
Device technical spectifications
General
Nominal voltage and frequency
Protection category
Protection index
Work temperature
Maximun ceiling slope on which it can be installed
Weight
Power consumption in standby mode (W)
Service value measurement standard
LED
Wattage
Flux
Color temperature
RGB
Data measurement
12
Nº of ON/OFF cycles
Nº of hours of lifespan
Dimmable
Angle
CRI
This product have a light source of energy efficiency class
Fan
Speed
Power (W)
RPM
Airflow (m³/min)
Airflow (m³/h)
Max noise level (dB)
Service value SV ((m³ / min) / W)
Maximum air speed (m / sec)
Bluetooth
Version
Speaker
Wattage
Control
CIF A28763647
that may occur. It must be understood that common sense,
precaution, and care are factors that cannot be included in all
products. These factors can and must only be provided by the
user who maintains and enjoys this fan.
220-240V~AC 50/60Hz
+34 916774540
Calle Verano, 51 - Polígono Industrial Las Monjas -28850 Torrejón de Ardoz - Madrid (ESPAÑA)
Preparing for installation
Note: The estimated installation time is 120 minutes. This
product can only be installed by a certified electrician Ca-
refully separate the fan's parts, avoiding the use of cutters
or blades that could scratch any part of it.
Remove the fan from the packaging carefully, avoiding the
use of knives which could scratch any part of it.
Remove all the components. Place the motor on a cloth or
wet surface so as not to damage its surface finish. Carefully
handle the unit to make sure that its casing does not bend
or get scratched.
Clase I
The fan must be mounted on the floor or a large enough
IP20
table to prevent any component from falling off.
-5
40ºC
↔
Instructions for synchronizing the
0º
receiver and the remote control
5Kg
The control is already factory-linked with its receive.
<0,5
Make sure all connections are correctly made.
EN 62879:2020
Make sure that the remote control contains batteries.
Make sure that all switches (main and isolation) are on.
The control of this fan have two mode of synchronization,
55W
Universal mode and Unit mode:
5500lm
- Unit Mode:
3000 - 6000K
This type of synchronization allows you to control two or
No
more nearby fans independently, each with its remote con-
trol.
360º Sphere
Synchronization:
10000
The control of this fan does not require synchronization
30000h
with the receiver, the control is already factory-linked with
Yes
its receiver
- Universal Mode:
120º
This type of synchronization allows you to control one or
>80
more nearby fans with the same remote control.
E
Synchronization:
1.-Connect the power (wall switch) of the fan or fans that
you want to control, and then just within the following
15 seconds, press the key
6
2.-A "beep" sound indicates that the connection has been
23
executed and the equipment can function normally.
1050
3.-Now, transmitter and receiver of the fan / s will have
been synchronized. Turn off the fan / s current using the
200
switch or automatic and then turn it back on / s, this step
12000
is the one that closes the synchronization process.
54
It is not possible for a controller to forget a fan once it has
11,91
been linked, if you want a fan to leave
to obey a command, another one must be linked to
6,63m/s
"overwrite it".
4.0
5W
Bluetooth
ATC: 916749481 - info@sulion.es / SAT : 916749483 - sat@sulion.es
Remote control
Change color
temperature
3000/4000/6000K
Dim color
temperature
Turn Off All
Timer
Play the music on Sulion fan.
How to connect you device:
1. Make sure the fan is connected
2. Activate the Bluetooth from your device (phone, laptop
or Tablet).
3. Search the device "Speaker Light" in the list of available
devices and pair it.
4. Enjoy the music
Light color temperature change
You can change the color temperature of the light, turning
off and on, with the wall switch, the remote control or in
of the remote control 3 times.
case of being an IoT fan from your terminal.
ON
WARM
Change light
intensity
Turn Off Fan
Turn On/Off Light
Speeds
Change direction
rotation
13
OFF
ON
NEUTRAL
OFF
COLD
OFF
ON
www.sulion.es
Publicidad
