Publicidad
Idiomas disponibles
Idiomas disponibles
36
MAINTENANCE
MAINTENANCE
Care
Cleaning the Water Inlet Filters
If the washer detects that water is not entering the
dispenser, an error message will show on the display. If
you live in an area with hard water, this may be caused by
clogged inlet filters.
NOTE
y Use extreme care when removing and cleaning the
filters. If the filters cannot be cleaned or are damaged,
do NOT operate the washer without the inlet filters.
Contact LG Customer Service or a qualified LG servicer.
Turn off both water taps completely. Unscrew the hot and
cold water lines from the back of the washer.
Inlet Filter
Carefully remove the filters from the water inlets, and
soak them in white vinegar or a lime scale remover. Rinse
thoroughly before reinstalling. Press the filters back into
place and reattach the water lines. Do NOT operate the
washer without the inlet filters.
WARNING
y Unplug the power cord and turn off the faucets before
cleaning. Failure to do so may cause electric shock.
y Do not use the washing machine without the inlet
filters. If you use the washing machine without the
inlet filters it will cause leaks and malfunction.
y If you use the washing machine in an area with hard
water, the inlet filter may clog due to lime buildup.
Contact your nearest LG customer service center if the
inlet filter is not clean or is missing.
NOTE
y P message will blink on the display when the water
pressure is weak or an inlet filter is clogged with dirt.
Clean the inlet filter.
Hot
Cold
Care in cold climates
When the Water Line is frozen
1
Turn off the faucets connected with the water lines.
2
Pour hot water on the frozen faucets to thaw the water
lines and pull them out.
3
Immerse the water lines in hot water to thaw them.
4
Connect the water lines with the water inlets of the
washing machine and faucets.
5
Turn on the faucets.
6
Touch the power button.
7
Select the Rinse & Spin cycle.
8
Make sure that the water fills properly.
When the Drain Line is Frozen
1
Pour hot water in the washer tub and close the door.
Leave it for 10 minutes.
2
Touch the Power button after 10 minutes.
3
Select the Spin Only cycle.
4
Make sure that the water drains.
Caring for the LCD Display
To remove dust or light dirt, wipe the surface with a dry,
clean, soft cloth. To remove major dirt, wipe the surface
with a soft cloth dampened in clean water or diluted mild
detergent. Then wipe immediately with a dry cloth.
CAUTION
y Do not push, rub or hit the surface with your fingernail
or a sharp object. This may result in scratches on the
screen and image distortions.
y Do not use any chemicals, such as waxes, benzene,
alcohol, thinners, insecticides, air fresheners or
lubricants. They may damage the screen's finish and
cause discoloration.
Publicidad
