Husqvarna LC 141iV Manual De Usuario página 20

5. Move the knobs up in the direction of the handle until
they stop and you hear a click. Tighten the knobs
fully. (Fig. 36)
To assemble the grass catcher
1. Push the 2 transportation covers out and down. (Fig.
37)
2. Put the top part of the grass catcher onto the lower
part of the grass catcher. Attach the grass catcher
frame with the clips. (Fig. 38)
3. Lift the rear cover.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To set the product in operation position
If the handle is put in transport and storage position (see
To set the product in transport position on page 25 ), do
the procedure that follows to put the handle in operation
position.
1. Lift the handle until the lower handle locks into
operation position. (Fig. 41)
2. Move the lower knobs up in the direction of the
handle until they stop and you hear a click. (Fig. 36)
3. Tighten the knobs.
4. Lift the upper handle and tighten the knobs. (Fig. 42)
To set the cutting height
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height. (Fig. 43)
20
Operation
Before you operate the
4. Attach the hooks on the grass catcher to the top
edge of the chassis. (Fig. 39)
To assemble the mulching-kit
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the grass discharge channel.
The mulch plug of type A is for LC 141i and
LC 141C. Type B is for LC 141iV. (Fig. 40)
3. Close the rear cover.
4. Replace the blade with the Combi blade, see
remove and replace the blade on page 23 .
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Battery status
The display shows the remaining battery capacity and if
there are problems with the battery. The battery capacity
is shown for 5 seconds after the product is switched off
or the battery indicator button is pressed. The warning
symbol on the battery is on when an error has occurred.
Battery on page 24 .
See
(Fig. 44)
LED lights
All LEDs are lit
LED 1, LED 2, LED 3 are
lit
LED 1, LED 2 are lit
LED 1 is lit
LED 1 flashes
To charge the battery
Charge the battery before the first use. The battery is
only 30% charged when supplied to the customer.
To
Do not set the cutting height
Before you use the battery,
Battery status
Fully charged (75-100%)
The battery is 50%-75%
charged
The battery is 25%-50%
charged
The battery is 0%-25%
charged.
The battery is empty.
Charge the battery.
919 - 011 - 16.08.2023