Makita ADCB200 Manual De Instrucciones página 11

Using the belt hook on the battery
holder
If you hang the battery holder on your waist belt, attach
the belt hook of the battery holder to your waist belt.
And then connect the jack of the adapter cable to the
battery holder and connect the plug of the adapter cable
to the jack of the power cable.
► Fig.8: 1. Belt hook 2. Battery holder 3. Waist belt
4. Adapter cable 5. Power cable
The battery holder has an anti-drop function. When
removing the battery holder from the belt, pull up the
battery holder while pressing the unlock button.
► Fig.9: 1. Unlock button
FUNCTIONAL
DESCRIPTION
Power button
To turn on the blanket, connect all the cables, press the
power button on the battery holder, and then press and
hold the power button on the blanket for a few seconds.
To turn off, press and hold the power button on the
blanket.
NOTE: The power button and power level indicator on
the battery holder are not used with the blanket. Only
the power level indicator 4 will light up when using the
blanket.
► Fig.10: 1. Power level indicator
NOTE: The battery holder automatically turns off
approximately 1 hour after the blanket is turned off.
Temperature adjustment
CAUTION:
For continuous operation, set the
temperature setting to "low" (blue). If the heating
section touches the same part of the skin for a long
time, there is a possibility of low temperature burns.
There are three temperature settings (high, medium,
low). When you switch on the blanket, the temperature
is set to "high". Each time you press the power button,
the temperature setting changes as shown in the figure.
The color of the power button shows the current setting.
► Fig.11: 1. Red: "high" 2. White: "medium" 3. Blue:
"low"
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► Fig.12: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted
(For 14.4 V and 18 V batteries only)
(For 14.4 V and 18 V batteries only)
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Battery protection system
The device is equipped with a battery protection sys-
tem. This system automatically cuts off power to the
heating parts to extend battery life. If the remaining
battery capacity is too low, the device will not operate.
When you turn the device on, the power is supplied to
the heating parts again, but stops soon. In this situation,
remove and recharge the battery cartridge.
Connecting USB devices
CAUTION:
Connect only devices that are
compatible with the USB power supply port. Not
doing so may cause a malfunction of the battery
holder.
NOTICE:
Before connecting a USB device,
always back up the data on the USB device. Not
doing so may cause a loss of your data.
NOTICE:
The battery holder may not supply
power to some USB devices.
NOTICE:
When not using or after charging,
remove the USB cable and close the cover.
11 ENGLISH
Off Blinking
malfunctioned.
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have