Publicidad
Idiomas disponibles
Idiomas disponibles
Always disconnect the appliance from the
electricity
main
adjustments. All seals must be replaced by the
technician at the end of any adjustments or
regulations. Our burners do not require primary
air adjustment.
10) TAPS
"Reduced rate" adjustment
- Switch on the burner and turn the relative knob to
the "Reduced rate" position (small flame fig.1).
- Remove knob "M" (fig. 13 a/b) of the tap, which is
simply pressed on to its rod.
33
ADJUSTMENTS
before
making
- Insert a small screwdriver "D" into hole "C" (fig.
any
14) and turn the throttle screw to the right or left
until the burner flame has been adequately
regulated to the "Reduced rate" position.
Check that the flame does not go out when the
knob is sharply switched from the "Full on" to the
"Reduced rate" position.
It is understood that only burners operating
with G20 gas should be subjected to the above
mentioned adjustments. The screw must be
fully locked when the burners operate with G30
or G31.
Publicidad
