JOCCA 2169 Manual De Instrucciones página 6

EN English
CONTROLLER ASSEMBLY:
- Loosen the two thumb screws located on the back of the fan header/controller.
- Do not unscrew completely, the two nuts will fall off.
- Locate the two holes under the fan header/controller. Assemble the two tubes
and push them down until it stops.
- Tighten the two thumb screws.
FAN BLADE AND SAFETY GRID ASSEMBLY:
- Install the rear grid, the rear grid fixing nut, the blades and finally screw the blade
fixing.
- Install the front grid and the Frame (front grid and rear grid junction) and secure
them using the screw on the frame. Insert the upper flexible hose from the motor
unit into the mist vent at the front of the fan grill (make sure the hose is not kinked).
MIST GENERATOR AND WATER TANK
- Place the mist generator on the base, making sure it is correctly seated in the
recess
- Place the water tank on top of the mist generator. Place the lid on top of the water
tank.
6