JOCCA 2169 Manual De Instrucciones página 7

English EN
- Insert the lower flexible hose of the motor unit into the water tank cover (make
sure the hose is not twisted).
FILLING THE WATER TANK
- Unplug the appliance before filling and cleaning the water tank.
- Remove the water tank and turn it over.
- Turn the lid counterclockwise to unlock it.
- Fill the tank with cold, clean water, making sure not to overfill it.
- Put the cover back on and turn it clockwise to snap it into place.
- Turn the tank over and place it back into the mist generator.
ATTENTION!
- Make sure the product is unplugged from the mains before filling or refilling the water
tank.
- Use only water in the water tank. Do not add chemicals, oils or other additives.
- Use only hot or cold water in the water tank. The water should not be hotter than
40°C.
INSTRUCTIONS FOR USE
1. Fan function:
- Switch the timer knob to the "ON" position.
- Set the wind speeds (low-medium-high) by pressing the "1/2/3" buttons.
- Press the "0" button to turn off the fan.
2. Oscillation function:
The fan is equipped with an oscillating feature where when activated the fan head
will swing from side to side.
- To activate, press the swing button down.
- To stop oscillation, pull the button up when the fan head is in the desired position.
3. Manual tilt:
Hold the fan head securely. Then undo the wing screw on the right-hand side of the
fan head. You can now tilt the head upwards and downwards to adjust the angle.
After adjusting the angle, tighten the wing screw again.
4. Cooling using ultrasonic mist:
- Press the "Mist" button to turn on the mist.
- Turn the mist knob to increase or decrease the mist level.
- When the mist function is selected, the water indicator light will turn green.
- If the water tank is empty (or lacks water), the indicator light will turn red.
- Press the "0" button to turn off the mist.
- The mist function and the fan function can be operated independently or together.
7