ATH-Heinl Comfort Lift 2.55XL Manual De Instrucciones página 96

Use the base plate of the column as a drilling guide.
Drill the holes with a percussion drill D.20, 150 mm deep. Be careful not to drill out the hole to ensure the
maximum holding force of the anchors.
Clean each hole thoroughly with compressed air or a wire brush to remove dust. Be careful not to move the
columns.
Fill the glue into the holes.
Install the washers and nuts on the anchor rods.
Insert the anchor rods into the holes filled with glue.
Check that the column is level.
If it is necessary to align the column, place the U-sheets in the appropriate places under the base plate.
Once the column is aligned, tighten the anchors.
Repeat the procedure for all columns.
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
96
a
b
a < 10mm
b < 10mm
Release date: 18.08.2023 / Product manufacturer ATH-Heinl GmbH & Co. KG
e
c
d
f
c < 10mm e < // 1 3,6mm
f < // 1 3,6mm
d < 10mm