Onvis HS2 Guida Rapida página 2

QUICK START GUIDE
1. Insert the included 1 CR2450 button cell battery and close the cover.
EN
2. Make sure the Bluetooth of your iOS device is on.
3. Use the Home app, or download the free Onvis Home App and open it.
4. Tap the 'Add accessory' button, and scan the QR code on the HS2 to add the accessory to your
HomeKit network.
Note: When QR code scanning is NOT applicable, select the target device (last 6 digits matching
the MAC address), and manually input the SETUP code printed on the cover page.
If the app prompts "Couldn't add Onvis-XXXXXX", please reset and re-add the device. Please keep the
QR code for future use.
The use of a HomeKit-enable accessory needs the follow permissions:
a. Settings>iCloud>iCloud Drive>Turn On
b. Settings>iCloud>Keychain>Turn On
c. Settings>Privacy>HomeKit>Onvis Home>Turn On
5. Name the HS2 smart multi-switch. Assign it to a room.
6. Set up a HomeKit hub (HomePod Mini and Apple TV4K2021) to enable BLE+Thread connection,
remote control and notification.
7. For troubleshooting visit:
HomeKit Hub Setting
Controlling this HomeKit-enabled accessory automatically and away from home requires a HomePod,
HomePod mini, or Apple TV set up as a home hub. It is recommended that you update to the latest
software and operating system.
To build an Apple Thread network, Apple HomePod mini or TV4K2021 is required.
You may find the instruction here:
http://www.onvistech.com/page-1717.html
http://www.onvistech.com/page-1718.html