Lionelo Braam i-Size Manual De Usuario página 19

SEAT REMOVAL – STABILISATION LEG
Press the stabilisation leg adjustment button (13, fig. B) and then push in the extension part
of the leg. The stabilisation leg latch indicator will turn red. Fold the stabilisation leg (fig. 27).
SEAT REMOVAL – ISOFIX
Push in the ISOFIX sliding lever (20, fig. B) on both sides and disengage the ISOFIX arms. The
anchorages will be released and the colour of the ISOFIX indicators will change from green
to red. Retract the ISOFIX arms into the seat base by pressing the sliding lever (20, fig. B).
SEAT BELT REMOVAL
1.
Unbuckle the 5-point seat belts by pressing the red button on the buckle (fig. 16).
2.
Remove the 5-point seat belt buckle from the crotch cover (fig. 17). Pass the buckle
through the hole in the cover (fig. 18) and place it in the storage compartment located
in the seat, under the cover.
3.
Pull the headrest adjustment lever (A, fig. 31) and lift the headrest upwards (fig. 19) so
that the holes in the backrest and headrest are at the same height (fig. 20).
4.
Unfasten the cushions of the 5-point seat belts (fig. 21) and then put them through the
holes in the backrest (fig. 22).
5.
Press the belt adjustment button and pull to loosen the shoulder belts. (fig. 23)
6.
Detach the cover (fig. 24).
7.
Put the shoulder belts together with the buckle in the place indicated in the picture,
located in the seat backrest (fig. 25).
8.
Fasten back the cover you have just detached (fig. 26).
HEADREST ADJUSTMENT
To change the height of the headrest:
1.
While holding the button to adjust the tension of the seat belts (8), loosen the belts,
this will allow you to adjust the height of the headrest more freely
2.
pull the headrest adjustment lever (fig. 12).
The headrest should be adjusted so that the shoulder belts are not too high, for example at
or above the ear line, nor too low, for example behind the child's back (fig. 13).
There are 14 headrest height levels available.
SEAT TILT ADJUSTMENT
To adjust the seat tilt, push in the tilt adjustment lever (fig. 30) and move the seat to the
‑ 19 ‑ EN