TFA 30.3066 Instrucciones De Uso página 16

TFA_No. 30.3066_Anleitung
MARBELLA – Wireless pool thermometer
• Change the batteries of the pool sensor, when the battery symbol
appears on the lower display next to the pool temperature or on the
pool sensor display.
• Change the batteries of the corresponding transmitter when the bat-
tery symbol "1" or "2" appears on the upper display or on the sensor
display.
• Please note: When the batteries are changed, the contact between the
transmitter and the base station must be restored – so always insert
new batteries into all devices or start the manual search for the trans-
mitter.
11. Troubleshooting
Problem
No indication on the
base station/transmitter
No DCF reception
No reception
of the pool sensor
Display "---"
30
16.01.2019 9:51 Uhr
Solution
➜ Ensure the batteries' polarities are
correct
➜ Change the batteries
➜ Start scanning with the SET/RCC
button
➜ Wait for an attempt reception during
the night
➜ Choose another place for the base
station
➜ Check if there is any source of
interference
➜ Restart the base station according to
the manual
➜ Set the clock manually
➜ No pool sensor installed
➜ Check the batteries of pool sensor
(do not use rechargeable batteries!)
➜ Start the manual search for the pool
sensor:
Press and hold the CHANNEL/SEARCH
button on the base station (while the
indoor values are displayed)
➜ Restart the pool sensor and the base
station according to the manual
Seite 16
MARBELLA – Wireless pool thermometer
No transmitter reception
Display "---"
Incorrect indication
If your device fails to work despite these measures, contact the retailer
where you purchased the product.
12. Waste disposal
This product has been manufactured using high-grade materials and
components which can be recycled and reused.
Never dispose of empty batteries and rechargeable batter-
ies with ordinary household waste.
As a consumer, you are required by law to take them to
your retail store or to an appropriate collection site
depending on national or local regulations in order to pro-
tect the environment.
➜ Choose another place for the base
station
➜ Reduce the distance between the
pool sensor and the base station
➜ Check if there is any source of
interference
➜ No transmitter installed
➜ Check the transmitter batteries
(do not use rechargeable batteries!)
➜ Start manual search:
Press the CHANNEL/SEARCH button
on the base station for three seconds
(while the values for channel 1 or 2
are displayed) and then press the TX
button in the transmitter's battery
compartment
➜ Restart the transmitter and the base
station according to the manual
➜ Choose another place for the trans-
mitter and/or the base station
➜ Reduce the distance between the
transmitter and the base station
➜ Check if there is any source of inter-
ference
➜ Change the batteries
31