Descargar Imprimir esta página

RIDGID R474 Manual Del Operador página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
TO MOVE THE BAND SAW
See Figures 29 - 30, page 28 - 29.
WARNING:
To avoid possible injury and before attempting to
move the saw, unplug the saw from the power sup-
ply and remove the switch key.
NOTE: This saw is top heavy, use caution when moving.
To Unlock the Mobile Stand:
 Unplug the saw.
 Step down on the front of the pedal to unlock.
 Roll the saw to the desired location making sure the
surface is firm and level.
To Lock the Mobile Stand:
 Step down on the pedal to lock.
 If the feet on the leg stand are not resting firmly on the
surface, readjust the leveling feet as necessary.
ADJUSTMENTS
WARNING:
Before performing any adjustment, make sure the
tool is unplugged from the power supply and the
switch is in the OFF position. Failure to heed this
warning could result in serious personal injury.
INSTALLING AND ADJUSTING THE BLADE
See Figure 33, page 30.
 Remove the table pin and the throat plate from the saw table.
 Rotate saw table so slot is on the left side of the saw then
remove the saw table.
 Turn the lock knob counterclockwise to unlock the blade
guide. Raise the blade guide as high as it will go. Turn
the lock knob clockwise to retighten.
 Turn the blade tension knob counterclockwise to release
tension on the blade.
 Open the upper and lower cover by pulling on the knobs.
 Place finger on the dust chute tab and pull the dust chute
open.
 Wearing gloves, carefully remove the old blade.
TILTING THE TABLE
See Figure 31, page 29.
 Turn the lock knob counterclockwise to unlock the blade
guide. Raise the blade guide as high as it will go. Turn
the lock knob clockwise to retighten.
 Loosen the table lock knobs slightly.
 Tilt the saw table toward the front of the saw housing
until it reaches the desired angle.
 Using the scale indicator, check angle markings.
 Retighten the table lock knobs to hold saw table securely
in place.
 Adjust blade guide as described in the Assembly
section.
CIRCLE CUTTING
See Figure 32, page 30.
 Adjust the upper guides to vertically just clear the
workpiece.
 Use both hands while feeding the work into the blade.
Hold the workpiece firmly against the table. Use gentle
pressure, and do not force the work, but allow the blade
to cut.
 The smallest diameter that can be cut out is determined by
the width of the blade. For example, a 1/4 in. wide blade
will cut a minimum diameter of approximately 1-1/2 in.
 From arm's length, carefully uncoil the new blade. If the
new blade was oiled to prevent rusting, it may need to be
wiped to keep the oil off the workpiece. Carefully wipe in
the same direction the teeth are pointing so the rag does
not catch on the teeth of the blade.
 With the teeth of the blade toward the left of the saw
and facing downward, place the blade through the blade
guides and around both wheels.
 Slowly turn the upper wheel to the right or clockwise by
hand to center the blade on the rubber tires.
 Turn the blade tension knob clockwise to tension
the blade. See Assembly section "Adjusting Blade
Tension".
 Adjust the tracking of the blade. See Assembly section
"Tracking the Blade".
 Close upper and lower covers, and dust chute.
 Replace saw table, throat plate, and table pin.
 Adjust blade guide as described in the Assembly
section.
16

Publicidad

loading