IPC CT110 BT85 Manual De Instrucciones página 73

At the end of charging with
the electronic battery
charger, the battery does
not provide the correct
voltage (about 2.14 V per
element without load) and
only one or a few elements
appear flat when tested
with the hydrometer
The electrolyte in
battery is turbid
the battery charger does not work
one or more elements are damaged
the the battery has reached the end of
the charging/discharging
declared by the manufacturer
the battery has been charged with
too high a current
the battery has
beyond the
recommended by the manufacturer
make sure there is voltage to the
battery charger, that the fuses are
not blown and that the current
reaches the battery; try charging
with another rectifier. If the battery
charger is not working, contact the
technical
indicate the serial number of the
battery charger
if possible, replace the damaged
elements.
For 6 or 12 V single block batteries,
replace the entire battery
replace the battery
cycles
replace the battery
been charged replace the battery
maximum limit
service centre and
ENGLISH
25