Stop The Machine; Adjust The Depth Of Cut; Replace The Blade; Operation Tips - GreenWorks 82E8 Manual Del Operador

EN
9.3

STOP THE MACHINE

1. Release the trigger to stop the machine.
9.4

ADJUST THE DEPTH OF CUT

1. Remove the battery pack.
2. Loosen the depth adjustment knob to increase or
decrease the depth.
Depth Adjustment Knob
3. Adjust the depth so that the blade barely touches
the ground when the machine is held in a normal
operating posture.
4. Tighten the depth adjustment knob.
5. Standing in a normal working position, check the
depth of cut again and correct if necessary.
6. Replace the battery pack once all adjustments are
complete.
9.5

REPLACE THE BLADE

If the blade worn out, replace it with a new one (not
provided).
1. Use a metal rod (1) to fix the blade.
2. Remove the nut (2) by turning it counterclockwise
with the wrench (4) provided.
3. Remove the washer(3).
Wheel
Blade
NOTE
English
4. Remove the old blade and replace it with a new one.
5. Place the washer on the blade.
6. Place the nut on the washer and tighten it
counterclockwise with the wrench provided.
Loosen
9.6

OPERATION TIPS

Always hold the edger away from the body keeping
clearance between your body and the edger. Any
contact with the edger cutting head while operating
can result in serious personal injury.
• Hold the edger with your right hand on the rear
handle and your left hand on the front handle.
• Keep a firm grip with both hands while in operation.
• Edger should be held at a comfortable position with
the rear handle about hip height.
• The edger will edge along sidewalks, driveways,
flower beds, curbs, and similar areas.
• Cut at a steady pace. If the blade begins to bog
down, you are edging too fast; slow your pace. Do
not force the blade into ground.
• Light contact of the blade against the sidewalk edge,
curb, etc., is acceptable and will not damage the
edger.
• Best appearance is obtained when grass is dry.
Avoid edging in wet soil or wet grass areas or the
blade guard might clog and result in an uneven
edge. If the blade guard becomes clogged, stop the
8
2
3
Tighten
4
WARNING
1