Maintenance; General Information; Clean The Machine; Replace The Skid Plate - GreenWorks 82E8 Manual Del Operador

edger, remove the battery, and remove debris from
the blade guard.
10

MAINTENANCE

IMPORTANT
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
IMPORTANT
Make sure that all nuts, bolts and screws are tight.
Examine regularly that you install the handles tightly.
IMPORTANT
Use only the replacement parts and accessories of the
initial manufacturer.

10.1 GENERAL INFORMATION

IMPORTANT
Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety
glasses.

10.2 CLEAN THE MACHINE

• Clean the machine after use with a moist cloth
dipped in neutral detergent.
English
• Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.

10.3 REPLACE THE SKID PLATE

1. Remove the screws with a Phillips Head screwdriver
(not included).
2. Replace with the new skid plate (1).
3. Tighten the screws.

10.4 REPLACE THE WHEEL

1. Remove the battery.
2. Remove the wing nut (1), washer (2), axle sleeve
(3), wheel (4), axle sleeve (3), rubber washer (5)
and wheel axle (6) orderly from the wheel assembly.
3. Replace with the new wheel.
4. Insert the wheel axle (6) through the slot (7)
downward, then put the rubber washer (5), axle
sleeve (3), wheel (4), axle sleeve (3), washer (2)
and wing nut (1) orderly through the wheel axle (6).
9
6
4
5
3
3
7
EN
1
2
1