Publicidad
Idiomas disponibles
Idiomas disponibles
charging or discharging must be stopped.
2, Avoid over discharge: charge the battery timely after discharging, in order to avoid the over-discharge.
Secondly: Requirements on storage
1.li-battery cannot be stored at the palace where is over hot and over humidity. therefore the temperature of the
storage should between -20 to 55degree,and further more the storage must be kept in dry, clean and the battery
should not be piled up.
2. the battery cannot be stored for a longtime without charging. The battery should be charged once a month.
The battery should be stored with fully charged.
Thirdly: Maintenance
1, When you test the voltage of the single piece of the battery-cell, you have to test the cell directly, not by the
wire. By doing that, it can avoid the voltage decline.
2,You have to wear the glove or clip the finger nails before you take out the single piece of the battery. So as to
avoid damage the cover of the battery.
3, Forbid bending the battery cell, the top edge of the seal-up. And also the falling ,hitting and short circuit are
prohibited .
4, When you re-assemble the battery, there are some special notes we have to concerned in mind. The
temperature of the electric iron should below 350℃; the welding time must be less than 3 seconds; and the
frequency of welding should be no more than 5 times; the second welding must be done after cooling.
15
Publicidad
