Teac CD-P750 DAB Manual Del Usuario página 8

1 – Introduction (continued)
Slot loading of discs
1.
As shown in the illustration, hold the disc with the labeled side
up and insert it part way into the slot.
2.
Push the disc in further until just before it disappears. It will
automatically be drawn in to the slot.
If a disc will not load properly
If a disc becomes stuck during insertion, for example, and is
difficult to push, do not try to force the disc in. Pull the disc out
once, press the EJECT (-) button, and then try inserting it again.
(Trying to force the disc in could damage the unit.)
SD cards and USB flash drives
This unit uses SD cards and USB flash drives for recording and
playback.
Precautions for use
SD cards and USB flash drives are delicate media.
In order to avoid damaging SD cards and USB flash drives, please
take the following precautions when handling them.
o Do not leave them in extremely hot or cold places.
o Do not leave them in extremely humid places.
o Do not let them get wet.
o Do not put things on top of them or twist them.
o Do not hit them.
o Do not remove or insert them during recording, playback, data
transmission or other access.
o When transporting them, put them into cases, for example.
SD card write protection
This unit writes track information to the media in order to improve
operation performance. Since track information cannot be written
to SD cards that are write-protected, the amount of time needed
to read media will become longer, for example.
8
Bluetooth® notes
This unit has a built-in Bluetooth audio receiver, and can output
sound played on a computer or portable audio device that sup-
ports Bluetooth wireless transmission (Bluetooth device).
ATTENTION
The Bluetooth function of this unit is not guaranteed to enable
connection or operation with all Bluetooth devices.
Profiles
This unit supports the following Bluetooth profiles.
o A2DP (Advanced Audio Distribution Profile)
o AVRCP (Audio/Video Remote Control Profile)
In order to transfer audio by Bluetooth wireless technology, the
Bluetooth device must support A2DP.
In order to control playback on the Bluetooth device, it must sup-
port AVRCP.
Even if a Bluetooth device supports the same profiles, though, its
functions might differ according to its specifications.
Codecs
This unit supports the following codecs. It will automatically select
one of them during audio transfer.
o SBC
o AAC
o Qualcomm® aptX™ audio
o Qualcomm® aptX™ HD audio
The unit will select the appropriate codec to use according to the
codec compatibility of the other Bluetooth device and communi-
cation conditions.
NOTE
i You cannot select the codec to be used by pressing a button,
for example.
i Due to characteristics of Bluetooth wireless technology, play-
back from a Bluetooth device will be slightly delayed compared
to playback from this unit.
Content protection
This unit supports SCMS-T as a form of content protection when
transmitting audio, so it can play protected audio.
Transmission security
This unit supports security functions during Bluetooth transmission
in accordance with the Bluetooth standard specifications, but it
does not guarantee the privacy of such transmissions.
TEAC CORPORATION will bear no responsibility should an informa-
tion leak occur during Bluetooth wireless transmission.