Mesko MS 7856 Manual De Uso página 5

14. For additional protection, it is advisable to install a residual current device (RCD) in the
electrical circuit with a rated residual current not exceeding 30 mA. Please consult an
electrician for this.
15. Do not allow the motor part of the device to get wet.
16. It is forbidden to insert fingers or any other objects into the grilles in the casing of the
device.
17. Do not cover the exhaust and rear grilles.
18. After finishing work, empty the water from the device before storing it away.
19. If the device will not be used for a long time, disconnect it from the mains.
20. Do not move the machine when there is water in the internal tank.
21. Do not place any objects on the device.
22. The device may only be used with efficient ventilation of the room.
• Be aware that high levels of humidity can encourage the growth of biological organisms in
the environment.
• Do not allow the area around the device to become damp or wet. If moisture occurs,
lower (reduce) the performance of the device.
• Do not allow absorbent materials such as carpets, curtains, tablecloths to get wet.
• When filling and cleaning, disconnect the device from the mains.
• Never leave water in the tank when the machine is not in use.
• Before storing the device, empty the water tank and clean the device.
• Clean the device and water tank before next use.
• WARNING: When the water is not replaced and the tank is not properly cleaned every 3
days, microorganisms that may be present in the water or in the environment where the
appliance is used or stored may grow in the water tank and be blown out to the
environment. This can cause a very serious health risk.
• WARNING: Every three days, empty the water tank and refill with clean water. Before
refilling, clean the tank with fresh tap water or detergents. Remove any scale, deposits or
film that has formed on the sides of the tank and on the inside surfaces. After washing,
wipe all surfaces dry.
Before first use
1. When the device is used for the first time, the device may produce an odor, which will disappear in the course of operation. You don't
have to do anything about it.
2. Always replace exhausted batteries in the remote control with new ones.
PRODUCT DESCRIPTION Bladeless air cooler Ms7856
1. Handle
3. Handle to manual up / down air flow direction control
5. Water level gauge
7. Back cover with net
9. Water tank
11. Ice boxes
13. Water tank lock
15. Pump
17. Filter latches
Remote control & Control panel – picture B
A – power button
C – fan speed button
E – timer button
OPERATION
A noticeable reduction in the temperature of the outlet air occurs after putting into the water tank (9) the plastic containers (11) included
to the product. The plastic containers should be previously frozen in the freezer for few hours. It is recommended to fill the plastic
B – mode button
D – timer button
F - wet cooling button
2. Air outlet
4. Front housing
6. Back housing
8. Evaporation filter
10. Remote control
12. Control panel
14. Pump latch
16. Cover's recess
5