Mx Onda MX-PG2200X Manual De Usuario E Instalacion página 22

INSTALLATION OF THE GAS HOB
¡Very important!
The installation of the gas hob must only be carried out by an authorized
installer. MX ONDA will not accept any liability and the guarantee will be
invalid in case of incorrect or incorrect installation.
The following instructions are for the authorized installer, installation and
maintenance must always be carried out by qualified personnel and / or
authorized technicians.
Warning: Unplug the gas hob from the electrical outlet before carrying out any
maintenance work.
Ventilation of the room
This gas hob must be installed and used in rooms with permanent ventilation
and adequate to current regulations. The following requirements must be
considered:
a) The room must be prepared with a ventilation system that facilitates the
exit of smoke and combustion gases to the outside. In specific cases it is
possible to resort to electric hoods or extractors to force ventilation.
b) The air inlet hole for ventilation must be large enough to allow an air flow of
at least 2 m³ / h per kW of installed heat capacity.
The outside air inlet duct for ventilation must have a minimum of 100 cm²
and should not be able to be blocked or obstructed easily.
Gas equipment without safety devices must have a ventilation twice the
volume of a protected equipment. For example, a minimum of 200 cm²
(Fig.3), another option (less advisable) would be to use an adjacent room
with ventilation inlet (Fig.4) in this case the door has to have enough slack
in the lower part to allow ventilation even if it is closed.
Through an extractor
8
Directly abroad