Celexon INF200 Manual De Usuario página 20

Attention:
During the inflation process, make sure that the frame does not twist and that
the motorised blower does not tip over. If necessary, support the frame while
setting it up.
STEP 5:
Use the guy accessories (D), to anchor
the screen and stop it from falling over.
Pass the pegs through the loops of the
lower frame and anchor them firmly in
the ground.
Tie the ropes to the the upper loops and
tighten them downwards at an angle of
approx. 60° downwards (Fig. 3).
DISASSEMBLY
Switch off the fan, unzip the frame and guide the screen with two people as
it „collapses". The frame should tilt backwards and the screen surface should
face upwards.
STEP 2:
Disconnect the pump from the power source, loosen the air hose and move the
blower and any extension cord or cable reel into the dry, Loosen all the pegs
from the ground and if necessary, remove the guy ropes from the frame. Place
the sharp pegs safely to one side.
STEP 3:
Hold the frame firmly with one person while the other releases the fabric from
the frame. Pull only on the outer band of the fabric to release it all the way
around.
Fig. 3: Anchoring the screen
8