Daikin FWXT10ABTV3 Manual De Instalación Y Funcionamiento página 21

CONTROL PANEL INSTALLATION AND CONNECTION
3.1 Board connections with TOUCHPAD AND REMOTE CONTROL
Before you connect the cooler-radiator, make sure
that:
- the voltage and frequency match the values on the
device's nameplate.
- The power line has an efficient ground connection and
is appropriately sized for the unit's maximum current
absorption (minimum cable section: 1.5 mm
If you need to replace the power cable, contact only
the technical customer service or qualified staff, in
compliance with the applicable national laws.
H2 water temperature probe 10 kΩ
M1
fan motor DC inverter
water solenoid valve (230V/50Hz 1A powered
Y1
output)
L-N
230V/50Hz electrical power supply connection
BO boiler consent output (free contact max 1 A)
CH chiller consent output (free contact max 1 A)
Connection diagram
See paragraph 4 on page 26 for the instructions for use with the Touchpad and remote control.
You can use a cable embedded in the wall in the position
traced with the installation template to make the electrical
connection
installed in the upper part of the wall).
In any case, you must check that the power supply is
protected against overload and/or short-circuits.
).
2
In order to prevent any risk of electric shock, it is essential
to disconnect the main circuit breaker before making any
electrical connections and performing maintenance on the
equipment.
CP
AIR
DISPLAY
SM
H2 AIR
M1
CH BO
LN
Y1
(recommended connection
presence sensor input (if open, the convector
goes into stand-by.)
optional air probe
control panel (display) wiring
step Motor connector
SM
for devices
EN
21