Important Information And Maintenance; Air Filter Removal And Replacement; Packaging; Use - AERMEC VED 430 Manual De Instrucciones

Tabla de contenido

Publicidad

IMPORTANT INFORMATION AND MAINTENANCE

WARNING: the fan coil is connected to power supply and hydraulic
circuit. Operations performed by people without the required
technical skills can lead to personal injury to the operator or
damage to the unit and surrounding objects.
ONLY POWER THE FAN COIL AT 230V ~ 50Hz
Any other type of power supply could permanently damage the fan
coil.
DO NOT USE THE FAN COIL IMPROPERLY
Do not use the fan coil for animal husbandry applications (e.g.
incubation).
AIR THE ROOM
Periodically air the room in which the fan coil has been installed. This is
particularly important if the room is occupied by many people, or if
gas appliances or sources of odours are present.
ADJUST TEMPERATURE ADEQUATELY
The external temperature should be adjusted in order to provide
maximum comfort to the people in the room, especially if they are
elderly, children or sick people; avoid differences over 7°C between the
outdoor temperature and the temperature inside the room in summer.
In summer, a temperature that is too low causes higher electrical
consumption.
CORRECTLY ADJUST THE AIR JET
Air coming out from the fan coil must not reach people directly; in fact,
even if the air is warmer than the room temperature, it could cause a
cold sensation and result in discomfort.
DO NOT USE EXCESSIVELY HOT WATER
Clean the fan coil with a soft cloth or sponge soaked in water not over
40°C. Do not use chemical products or solvents to clean any part of
the fan coil. Do not spray water on the outer or inner surfaces of the
fan coil (this might cause short circuits).
CLEAN THE FILTER PERIODICALLY
Cleaning the filter frequently guarantees enhanced operating
efficiency.
Check whether the filter is very dirty: in this case, clean it more often.
Clean frequently; remove the accumulated dust with a vacuum cleaner.
Once the filter is clean, refit it on the fan coil following the removal
instructions but in reverse order.
SUPPLEMENTARY CLEANING

AIR FILTER REMOVAL AND REPLACEMENT

The air filter must be removed from the fan coil for cleaning.
The cleaned or new air filter (for replacement) must be correctly fitted
and secured in its housing in the fancoil.
To remove the air filter:
- loosen the screws of the two filter clips
- slide the two filter retainers until they stop

PACKAGING

The fan coils are sent in standard packaging made of foam polystyrene and cardboard.

USE

Consult control panel manual for installation and use instructions.
10
IVEDLJ 1808 - 4880910_03
The fact that the blades of examinable shrouds can be removed
(operation done only by adequately skilled technicians) ensures a
thorough cleaning of the internal components, which is particularly
important when installing the unit in crowded areas or venues
requiring high hygiene standards.
DURING OPERATION
Always leave the filter fitted on the fan coil during operation
(otherwise dust in the air could soil the coil surface area).
WHAT IS NORMAL
In the cooling operation, water vapour may be present in the air
delivery of the fan coil.
In the heating operation, a slight hiss might be heard close to the fan
coil. Sometimes the fan coil might give off unpleasant smells due to the
accumulation of substances present in the air of the room (clean the
filter more often, especially if the room is not ventilated regularly).
While the unit is functioning, there could be noises and creaks inside
the device due to the various thermal expansions of the elements
(plastic and metal), but this does not indicate any malfunction
and does not damage the unit unless the maximum input water
temperature is exceeded.
MALFUNCTIONING
In case of malfunction, cut off power to the unit, then energise it
again and restart the device.
WARNING! Do not attempt to repair the unit alone, this is
extremely dangerous!
If the problem occurs again, call the local Aftersales Service
immediately.
DO NOT TUG THE ELECTRIC CABLE
It is very dangerous to pull, tread on or crush the electric power cable,
or fix it with nails or drawing pins.
A damaged power cable can cause short circuits and injure people.
DO NOT OBSTRUCT THE AIR OUTLETS BY PLACING OBJECTS
INTO THEM
Never insert objects of any kind in the air delivery and outlet.
This could injure people and damage the fan.
WARNING
Avoid that the device is used by children or incompetent persons
without appropriate supervision; also note that the unit should not
be used by children as a game.
- remove the filter from its housing
To reassemble the air filter:
- insert the air filter into its housing,
- slide the two filter clips until the filter is secured,
- tighten the screws of the two filter clips,
- make sure the filter is secured in its housing.

Publicidad

Tabla de contenido
loading

Tabla de contenido