Sears Kenmore 110.20372710 Manual De Uso Y Cuidado página 11

8.
Select cycle
Turn cycle knob to choose your wash cycle.
9.
Select cycle modifiers, if desired
Light soils Moderate soils
Colors that bleed Bright colors
or fade
Once you select a cycle, the default settings for that cycle
will be lit. Touch the cycle modifier buttons to change the Wash
Temp, Soil Level, and Spin Speed, if desired. Not all settings
are available with all cycles. Even for cold wash settings,
some warm water may be added to the washer to maintain
a minimum temperature�
NOTE: Always read and follow fabric care label instructions
to avoid damage to your items. If not sure which temperature
to use, refer to the diagram above or select a cooler
temperature�
10
Select any other cycle options you may wish to add if not
previously set. Some cycles will automatically add certain
options such as Two Rinses. These may be turned off,
if desired�
NOTE: Not all options are available with all cycles.
11.
Touch and hold the START/PAUSE/UNLOCK LID button for
up to 3 seconds to start the wash cycle. When the cycle has
finished, the Complete indicator will light and the end-of-cycle
signal will sound (if set). Promptly remove items when cycle
is done to avoid odor, reduce wrinkling, and avoid rusting of
metal hooks, zippers, and snaps.
Heavy Soils
Unlocking the lid to add garments
Whites
If you need to open the lid to add one or two missed items:
Pastels
Touch the START/PAUSE/UNLOCK LID button to pause
the washer; the lid will unlock once the washer movement
has stopped. This may take several minutes if the load was
spinning at high speed. Then close the lid and touch and hold
the START/PAUSE/UNLOCK LID button again for up to 3
seconds to restart the cycle.
IMPORTANT: If the lid is left open for more than 10 minutes,
the water will pump out and the F8E6 error code will appear
on the display.
.
Select cycle options
Touch and hold START/PAUSE/UNLOCK
LID button to begin wash cycle
11