Add A Garment - Sears Kenmore 110.20372710 Manual De Uso Y Cuidado

Lavadora de carga superior, de alto rendimiento y con nivel bajo de agua
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CYCLE SIGNAL
Use this option to adjust volume of the signal that sounds
at end of cycle. The Cycle Signal is a helpful reminder
to remove items from washer as soon as the cycle has
completed�
To turn Button Sounds Either On or Off:
While washer is on, touch and hold the CYCLE SIGNAL
button for 3 seconds. Washer will make a single beep
when the process is complete�
NOTES:
• The Cycle Signal button will still operate, even if you turned
the button sounds off.
• Whatever your preferences are, they remain in effect
through a power loss.
• The Default setting for the button sounds is on.
7
CYCLE OPTIONS
You may add or remove options for each cycle. Note that
not all options can be used with all cycles, and some are
preset to work with certain cycles.
PREWASH
Use this option to add an extra agitation and soak time
to the beginning of any cycle to break up tough stains.
DEEP FILL
Will add the most amount of water for large or bulky
loads. Items need to move freely. Tightly packing the
load can lead to poor cleaning performance, and may
increase wrinkling and tangling.
TWO RINSES
This option can be used to automatically add a second
rinse to most cycles.
NOTE: If you want to drain and spin only, select the Rinse
& Spin cycle, then touch to turn off the Two Rinses option.
FABRIC SOFTENER
This option must be set to ON if using fabric softener.
It ensures that fabric softener is added at the correct
time in the rinse for even distribution�
STEAM TREAT
This option provides enhanced cleaning action for tough
stains. It will add additional agitation and soak time to
the cycle.
CYCLE STATUS LIGHTS INDICATOR
8
The Cycle Status lights show the progress of a cycle. At each
stage of the process you may notice sounds or pauses that
are different from traditional washers.
DELAY
When Delay Wash is selected, this light will come on
to indicate your washer is set up to run a delayed wash.

ADD A GARMENT

You may place additional clothing in the wash when the
Add a Garment indicator is lit without sacrificing wash
performance� Touch the START/PAUSE/UNLOCK LID
button once. The Lid Locked light will turn off. Open the
washer lid, add garments, and close the lid. Touch and
hold the START/PAUSE/UNLOCK LID button to restart�
WASH
The washer will fill to the correct water level based on
the load size and the Water Level selection. Certain cycles
may agitate during the fill process to boost cleaning. You
will hear the agitator rotate followed by a pause lasting
several seconds. When the wash cycle begins, you will
hear the agitator increase speed. The motor sounds may
change at different stages in the wash cycle while the
washer performs different wash actions.
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load� Fabric softener will
be added if the Fabric Softener option was selected�
SPIN
The washer spins the load at increasing speeds for proper
water removal based on the selected cycle and spin
speed�
COMPLETE
Once the cycle is complete, this light will come on.
Remove the load promptly for best results.
LID LOCKED
To allow for proper load sensing and spinning, the lid
will lock and the Lid Locked light will turn on. This light
indicates that the lid is locked and cannot be opened�
If you need to open the lid, touch the START/PAUSE/
UNLOCK LID button� The lid will unlock once the washer
movement has stopped. This may take several minutes
if the load was spinning at high speed. Touch and hold
the START/PAUSE/UNLOCK LID button again for up
to 3 seconds to resume the cycle.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido