Publicidad
Idiomas disponibles
Idiomas disponibles
25. AC CONNECTION
Plug the power supply cable in here.
5. INSTALLATION
Install the CD-player on a plane surface.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
The control panel's LCD's are designed to be clearly visible within the angles shown in Figure 1. Mount the
control panel so that the visual angle is within this range.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages.
Connect your CD-player with the mains.
CAUTION: Turn the amplifier on last and off first!
6. OPERATION
6.1 Setup
Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.
6.2 CD-tray
Press Open/Close-button in order to open the disc tray. The CD-tray opens, the status-LED flashes and the
display shows "OPEN".
Insert your CD in the CD-tray. Make sure that you only hold the CD with 2 fingers on the edge. Avoid
touching the inside area of the CD.
CAUTION: Do not close the tray by pushing it as this could harm the construction.
Press the Open/Close-button again in order to close the tray. The status-LED flashes until the tray is closed.
The LED is turned off and the player is ready for operation.
24/55
10602297_V_1_1.DOC
Publicidad
