Ego Power+ SNT2410 Manual De Funcionamiento página 31

CLEARING A CLOGGED CHUTE
(Fig. 14)
WARNING:
contact with the rotating auger inside the
chute is the most common cause of injury
associated with snow blowers. Never use
your hand to clean out the chute.
WARNING:
discharge chute or place any body part
in front of the snow blower when the unit
is operating or when the battery pack(s)
are installed. Always ensure all moving
parts have stopped and the battery pack(s) have been removed before clearing any
obstructions. Failure to follow these instructions can result in serious personal injury.
To clear the chute:
1. Stop the motors and power down the snow blower!
2. Remove the battery pack(s) from the snow blower.
3. Wait 10 seconds to be sure the auger has stopped rotating.
4. Always use the chute cleaning tool which is attached to the machine as an
accessory; DO NOT USE YOUR HAND.
BATTERY PACK HIGH-TEMPERATURE PROTECTION
If the battery pack(s) temperature exceeds 158°F (70°C) during operation, the
temperature-protection circuit will immediately shut off the snow blower to protect the
battery pack(s) from overheating damage. The power indicator on the snow blower
will be off and the LED indicator on the battery pack will flash orange or shine red
depending on the model.
NOTE:
The LED indicator on following battery packs will flash orange lights when
overheated: BA1400, BA1400-FC, BA2800, BA2800-FC, BA4200, and BA4200-FC;
the LEDs on following battery packs will shine red lights when overheated: BA1400T,
BA1400T-FC, BA2242T, BA2242T-FC, BA2800T, BA2800T-FC, BA3360T, BA3360T-FC,
BA4200T, BA4200T-FC, BA5600T, BA5600T-FC, BA6720T, and BA6720T-FC.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2410/SNT2410-FC
Hands coming in
Never reach into the
14
Chute Cleaning
Tool
31