Kalorik USK BL 16909 Manual De Instrucciones página 6

Fax +32 2 359 95 50
Once you have finished the preparation, stop the appliance
•
(position 0) and unplug the appliance.
Remove the jar from the base. Then remove the lid and pour the
•
liquid in the desired receptacle.
IMPORTANT: Always close the jar with the lid before starting mixing.
When mixing hot liquid, do not fill more than 2/3 of the jar and be
very careful in order to avoid splashing of hot liquid, otherwise you
can get burned. Do not forget to close the feeding hole of the
pouring jar with the cap.
CAUTION: IN ORDER NOT TO DAMAGE THE RUBBER PART ROTATING THE
BLADE, PLEASE WAIT UNTIL THE MOTOR HAS STOPPED COMPLETELY
BEFORE REMOVING THE JAR FROM THE MOTOR BLOCK.
HOW TO CLEAN
Always unplug from outlet before cleaning.
•
For a quick rinsing of the pouring jar (for example between two
•
preparations), you can use clear water and switch on your
appliance for a few seconds. In this case, do not use any
detergent.
For a full cleaning, remove the jar from the motor block and turn
•
the blade fixing ring on the bottom of the jar anti-clockwise to
detach the sealing ring and the blade (this will make the
cleaning easier). Then you can clean these parts with soapy
water and rinse thoroughly with clear water. Dry before
assembling. To attach the blades, put the sealing ring around the
blades, insert them in the bottom of the jar and tighten the fixing
ring by turning it clockwise (tighten vigorously in order to avoid
leaks). Caution, do not lose the seal during this operation.
You can wipe the motor block with a soft damp cloth.
•
CAUTION: AVOID CLEANING THE BLADES IN THE DISHWASHER TO
AVOID RUST ISSUES OF SOME OF THE PARTS. DRY THE PARTS UNDER THE
BLADES AFTER HANDWASH.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame,
6
Assembly page 6/24
special instruction from Team
Print only
USK BL 16909/16911 - 110127