Marathon Multi 600 Manual De Usuario página 23

9.3 Magnet sensor reset mode
Beeps are made 2 seconds after turning on the power switch while pressing both turbo switch
③ and forward/reverse selector(Rev.) switch ④ at a time, which mean the reset to magnet
sensor mode. BY turning speed control knob ②, it is possible to reset the mode to "Hi," "Lo"
and "rc" modes.
CAUTION
For safety, the above conditions have been already set when shipped and, therefore, do not
change them.
Reset mode
"Hi"
"Lo"
"rc"
9.4 Specifications
9.4.1 Control unit
- Model: SDE-S60/L60
- Power supply: AC200~240V, 50/60Hz
- Weight: 2.9kg
- Dimension: 94mm(W) x 268mm(D) x 228mm(H)
9.4.2 Motor handpiece
- Model: SDE-BH60S
- Speed: 1,000~50,000RPM
- Weight: 230g(not including the motor cord)
- Dimension: L159 x Ø27
- Cord length: 1.4m
9.4.3 Foot pedal
- Model: SDE-FS60
- Weight: 384g
- Cord length: 1.8m
9.4.4 Control unit stand
- Weight: 152g
- Dimension: 122mm(W) x 268mm(D) x 30mm(H)
9.4.5 Motor handpiece stand
- Weight: 68g
- Dimension: 60mm(W) x 110mm(D) x 45mm(H)
Function
High level reset
Low level reset
Recovery
How to reset
Beeps are made to reset the high level by
pressing forward/reverse selector (Rev.)
switch ④ while completely depressing knee
control panel ⑧.
Beeps are made to reset the low level by
pressing forward/reverse selector (Rev.) switch
④, without depressing knee control panel ⑧.
The magnet sensor reset mode is returned to
the main mode by pushing the
forward/reverse selector (Rev.) switch.