Sauder Cannery Bridge Serie Instrucciones De Montaje página 16

Step 11
å
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting
screw is against the stops as shown in the right diagram. If it isn't,
loosen the adjusting screw and mounting screw to slide it against
the stops. Then tighten the mounting screw.
å
Fasten one LEFT DOOR (H) to the LEFT END (A) as shown in the
lower diagram. Use the screws in the HINGES. You should start
each SCREW a few turns before completely tightening any of them.
å
Peel a BUMPER from the BUMPER CARD (10). Stick the BUMPER
onto the DOOR where it comes into contact with the DOOR STOP.
å
Repeat this step for the other DOORS (H and J).
å
See the next step for DOOR adjustments.
H
Page 16
A
J
10
www.sauder.com/service
H
17
Stop
Mounting
screw
Adjusting
screw
Hinge
J
429512