Sauder Steel River Serie Instrucciones De Montaje página 14

Step 9
å
Fasten the MOLDING (S) and SKIRTS (FF) to the
UPRIGHT FRAME (B). Tighten three 1/2" HEX HEAD
SCREWS (20) using the L-WRENCH (9).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
S
This hole must be
closer to this edge.
Page 14
FF
B
www.sauder.com/service
9
20
1/2" HEX HEAD SCREW
(3 used in this step)
This hole must be
closer to this edge.
FF
This hole must be
closer to this edge.
427851