Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 7

Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor. Save some
packing material for support to be used later in assembly.
å
Place the WASHER (82S) into one of the MOLDING
CONNECTOR CLIPS (173M) as shown in the enlarged
diagram. Using your hammer, gently tap on the WASHER to
insert the MOLDING CONNECTOR CLIP into the hole in the
LONG MODESTY PANEL (M).
å
Repeat this method to insert five MOLDING CONNECTOR
CLIPS (173M) into the LONG MODESTY PANEL (M).
å
Line up the groove in the LONG MODESTY PANEL
MOLDING (T) over the MOLDING CONNECTOR
CLIPS in the LONG MODESTY PANEL (M) and snap the
MOLDING onto the CLIPS.
å
NOTE: The MOLDING should be centered on the PANEL.
The groove
is closer to
this edge.
www.sauder.com/commercial-office/service
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
M
173M
Use your hammer to tap the WASHER (82S)
into the MOLDING CONNECTOR CLIP (173M).
82S
Be sure the MOLDING
CONNECTOR CLIP is
parallel to the long edge.
M
427803
0
Pro Tip: You will need
someone's help later
in assembly.
173M
T
Page 7