Sauder Whitaker Point Serie Instrucciones De Montaje página 39

Step 33
å
Before fastening the DOOR to your unit, be sure the
mounting screw is against the stops as shown in the
right diagram. If it isn't, loosen the adjusting screw and
mounting screw to slide it against the stops. Then tighten
the mounting screw.
å
Fasten the DOOR (Y) to the RIGHT END (B) as shown in
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
å
See the next step for DOOR adjustments.
429366 www.sauder.com/service
Stop
Mounting
screw
Adjusting
screw
Hinge
Y
B
17
Page 39