Sauder Whitaker Point Serie Instrucciones De Montaje página 8

Step 2
å
Separate the SHORT EXTENSION SLIDES (2) from the SHORT EXTENSION RAILS (1) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten four SHORT EXTENSION RAILS (1) to the LEFT END (A) and LEFT UPRIGHT (C). Use twelve 3/8" FLAT
HEAD SCREWS (28).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the END and UPRIGHT. Turn
a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
2
Push the black lever and pull the SLIDE from the RAIL.
1
Page 8
1
A
www.sauder.com/service
1
Use these holes.
3/8" FLAT HEAD SCREW
(12 used in this step)
1
1
C
7
28
429366