Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Initial operation
Always use the correct supply voltage: the power supply voltage
must match the information quoted on the tool identification
plate.
Switching On/Off
(RS-230)
Switching On
•
Press On/Off switch (1) on
Switching Off
•
Press On/Off switch (1) on
[F2]
(RS-380G)
Brief activation
Press the On/Off switch (1) and then let go again.
Continuous use
Switching On
•
Press On/Off switch (1) and retain with lock on button (7).
Switching Off
•
Press and release On/Off switch (1).
[F3]
Speed selection
(RS-380G)
With the thumbwheel (5) the required speed can be selected
(also while running).
The required speed is dependent on the material and can be
determined with practical trials.
After longer periods of work at low speed, allow the machine to
cool by running for approx. 3 minutes at maximum speed with
no load.
Operating instructions
Sanding
•
Hand the sander on the handle, so has to gain the best
possible control over your sanding operations.
•
Place tool with entire sanding face in contact with
workpiece.
•
Switch on tool and guide it in broad circular movements
over surface to be sanded.
•
Do not apply additional pressure to tool when sanding (the
tool is usually heavy enough itself to guarantee optimum speed
and good finish). Excessive sanding pressure does not lead to
increased sanding capacity, but increases wear of the machine
and the sand paper.
«I» position.
«O» position.
WARNING
Do not tilt! Sand in several stages, using a finer grain size each
time.
Maintenance and storage
CAUTION
Before any work on the machine itself, pull the mains plug.
•
Always keep the tool and the ventilation slots (if present)
cleaned. Regular cleaning and maintenance of the appliance
will ensure efficiency and prolong the life of your tool.
•
If the tool should fail despite the rigorous manufacturing
and testing procedures, the repair should be carried out by an
authorized IVT customer service.
•
Keep all nuts, bolts, and screws tight, to be sure the tool is in
safe working condition.
•
Replace worn or damaged parts for safety.
•
Use only original spare parts. Parts not produced by
manufacturer may cause poor fit and possible injury.
•
Store the tool in a dry room out of reach of kids and away
from any flammable material.
•
Never wet the device or spray water on it!
•
Use only mild soap and a slightly damp cloth to clean the
sander. Many household cleaners contain chemicals which could
seriously damage the plastic. Do not use petrol, turpentine,
lacquer, paint thinners or similar products.
Environmental protection
Recycle raw materials instead of disposing as
waste.
Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labelled for categorized recycling.
These instructions are printed on recycled paper manufactured
without chlorine.
15
Instruction manual
EN
Publicidad
