VATECH PaX-i3D Manual De Instrucciones página 44

4.3
PaX-i3D (PHT-6500) User Manual
Ask the patient not to block the ruler on the nasal
positioner by his / her fingers. It could deteriorate image
CAUTION
quality.
3. Click the Ready button after the patient has been properly positioned. No
X-Ray will be emitted at this point.
4. Proceed to section 4.3 Initiating X-Ray exposure.
Initiating X-Ray exposure
The X-Ray exposure method and process is the same for all CEPH modes.
The example and images below are taken from an X-Ray performed in CEPH
Lateral mode.
If a problem occurs during image acquisition, press the
red emergency stop button to immediately stop all moving
parts and cut off all power to the equipment's electrical
components. You may then safely release the patient from
the equipment.
To reset this button, turn it clockwise until it pops up.
WARNING
- Do not operate the PC during exposure.
- Failure to comply with this instruction may cause the
system to malfunction.
- The operator shall observe the X-Ray safety regulations
WARNING
applicable to their area at all times during the operation
of this equipment.
4 Acquiring CEPH Images
43