First use
Please wake up your toothbrush by pressing the on/off
button (7) and follow the instructions on the interactive
display (4) to get started for first time setup.
If not further instructed on the display, you may toggle
with the mode button (8) and select with the on/off
button (7).
You may change the settings via the «Settings» menu
(17) at any time.
Charging and Operating
• To charge the battery place the toothbrush on the
plugged-in charger (6).
• The charge level is indicated on the interactive display
(4). Once it is fully charged the display turns off. A full
charge typically takes 16 hours.
• If the battery is running low the motor reduces its
speed and the Smart Pressure Sensor (3) shortly blinks
in red. Once the battery is empty, the motor stops; it
will need at least a 5-minute charge for one usage.
Note: In case the battery is empty (display off), charge for
at least 30 minutes.
• You can always store the handle on the plugged-in
charger to maintain it at full charge; a battery over-
charge is prevented by the device.
Note: Store handle at room temperature for optimal
battery maintenance.
Caution: Do not expose handle to temperatures higher
than 50 °C / 122 °F.
Using your toothbrush
Start Brushing
Place the brush head on the handle. A small gap should
remain between handle and brush head. Lift the handle off
the plugged-in charger or simply pick it up to wake up the
handle (display turns on). Wet brush head and apply tooth-
paste. To avoid splashing, guide the brush head to your
teeth before switching the handle on by pressing the on/
off button.
Note: Display turns off after some time. You may press
the on/off button to activate display again.
Guide the brush head from tooth to tooth. Brush the
outsides, the insides and the chewing surfaces. Brush all
four quadrants of your mouth equally. You may also con-
9