Kongskilde CUC Manual Del Operador página 10

The Calibrate Screen menu allows for calibration of the touch screen in case this is necessary. The calibration must
be done with the desired pointing device (finger, pencil, eraser or similar).
CUC 1X2
180011010 (PLC)
180011000 (HMI)
10
The blower speed can be read out as either rpm or %, and the blo-
wer performance can be limited.
The maximum blower speed is 4.500 rpm, which is the value of the rpm
displayed by default. If the maximum blower speed should be limited,
press the value, i.e. the 4.500, and enter a new smaller value. This gives
the possibility to change the scale to other values lower than 4.500 rpm,
which is the maximum on the scale. This can give a better understanding
for the operator as the blower may not necessarily be able to reach ma-
ximum speed as this is dependent on the installation.
If the % key is selected, the RPM scale will change to a % scale.
An additional line will now appear at the bottom of the screen where the
ratio between 100% and RPM must be defined.
Version
CUC 1X2: Indicates the trim handler model
180011010 / 180011000: Displays the PLC / HMI software version
Remote / local control
The icon shows whether the trim handler is set for remote or local control.
Remote control: The trim handler is controlled via digital inputs on the
PLC (start/stop) and cannot be operated from the operator panel.
The trim handler will always be able to be stopped.
Local control: The trim handler is controlled from the operator panel. The
parameters that can be controlled from the control panel are selected by
the user Admin in the settings menu.