iRobot Roomba Combo j9+ Manual Del Usuario página 19

Regulatory Information
FCC Supplier's Declaration of Conformity
iRobot Corporation
Roomba
FCC ID: UFE-RCAY1 and IC: 6652A-RCAY1
Contains FCC ID: UFE-AXGY1 and contains IC: 6652A-AXGY1
This device complies with part 15 of the FCC Rules and ICES-003(B) / NMB-
003(B).
Charging Dock
Contains FCC ID: 2AC7Z-ESPC3MINI1 and contains IC: 21098-ESPC3MINI1
This device complies with part 15 of the FCC Rules and ICES-003(B) / NMB-
003(B).
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: 1) This device may not
cause interference, and 2) this device must accept any interference, including
interference that may cause undesired operation of the device.
• Changes or modifications not expressly approved by iRobot Corporation
could void the user's authority to operate the equipment.
• This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules as well as ICES-
003(B) / NMB-003(B) Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference to radio communication will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
Roomba Model: RCA-Y1
Charging Dock Model: ADK-Y1
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than the
necessary for successful communication.
• FCC Radiation Exposure Statement: This product complies with FCC
§2.1091(b) for mobile device RF exposure limits, set forth for an uncontrolled
environment and is safe for the intended operation as described in this
manual. Per FCC requirements, maintain a distance of more than 8 inches
(20 cm) between any person and the host device (Roomba Combo robot).
• ISED Radiation Exposure Statement: This product complies with the Canadian
Standard RSS-102 for mobile device RF exposure limits, set forth for an
uncontrolled environment and is safe for the intended operation as described
in this manual. Per ISED requirements, maintain a distance of more than 8
inches (20 cm) between any person and the robot.
iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA.
https://global.irobot.com
For battery recycling go to call2recycle.org;
or call 1-800-822-8837
Roomba Combo® j9+ Owner's Guide
EN
15