Style selections LWSCDS Manual Del Usuario página 5

ASSEMBLY INSTRUCTIONS
10.
a. Adjust floor levelers to level the unit against the wall
where desired.
b. Using back stretcher (E) as a template, mark three holes
to indicate where holes will be drilled.
c. Drill three pilot holes into the wall where previously
marked.
d. Make sure that the drilled holes fit the wall anchors
properly.
e. Press the anchors into the holes and gently tap with
a hammer until flush in the holes. PLEASE NOTE: If the
mounting hole coincides with a wooden stud, there is no
need for a wall anchor.
f. Align back stretcher (E) and back crossers (NN) over the
drywall anchors (MM) and secure with M5 x 65 mm
screw (OO).
g. Tighten screws securely with Phillips screwdriver.
If you want this unit flush against the wall, you can cut away
the baseboard of the wall, and then secure with M5 x 65 mm
screw (OO) without back crosser (NN).
Plug Plastic covers (II) to cover the cam locks for aesthetic
purposes.
Hardware Used
Plastic Cover
II
MM Drywall Anchor
Back Crosser
NN
M5 x 65 mm
OO
Screw
11. Drawer installation
1a. Extend the ball bearing slide tracks on the unit all
the way forward (including ball bearing cart).
1b. Align the slide runners on the assembled drawers
with the slide tracks and push the drawer carefully
inside until it stops.
NOTE: If the drawer does not go in smoothly, please take it
out and repeat the step. If you need to remove the drawer,
please pull the drawer all the way out, then simultaneously
pushes the plastic release lever of the ball bearing slides
up on one side and down on the other side, and then pull it
completely out.
10
Wall
MM NN
E
OO
x 4
x 3
x 3
x 3
11
Ball bearing cart
9
ASSEMBLY INSTRUCTIONS
12. This cabinet was designed with a feature that allows
stacking two units. Additional units sold separately. Insert
wood dowels (CC) into the holes on top of the base unit.
Place bottom of second unit onto the inserted dowels.
Secure units together by attaching the metal plates (EE)
at both ends with the M3.5 x 19 mm screws (JJ) into the
predrilled holes.
If you plan to use this unit as hutch (stand this on anoth-
er one), please skip step 9 &13.
II
NOTE: Remove caps (HH) before stacking two units
together.
Hardware Used
CC Wood Dowel
EE Metal Plate
JJ M3.5 x 19 mm Screw
13. Insert the caps (HH) into the holes on top of the top
panel (A).
Hardware Used
HH
Cap
12
CC
x 4
x 1
x 4
13
x 4
10
JJ
EE
HH