Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
• ALWAYS USE SAFETY GLASSES. Also use face or dust mask if cutting operation is dusty. Everyday
eyeglasses only have impact-resistant lenses; they are NOT safety glasses.
• USE RECOMMENDED ACCESSORIES. Consult the owner's manual for recommended accessories.
The use of improper accessories may cause risk of injury.
• NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if the cutting
tool is unintentionally contacted.
• Use only cutting discs that are suitable for the product.
• Only use cutting discs in good working condition. Remove damaged or worn cutting discs immediately.
• NEVER use segmented cutting discs.
• Faults in the machine, including guards or diamond discs, should be reported as soon as they are
discovered. NEVER use the machine without the guard in position.
• DO NOT twist or bend workpieces.
• NEVER cut several workpieces simultaneously. DO NOT cut bundles made of several individual pieces.
A workpiece can get caught in the cutting disc and fly out of control.
• NEVER cut workpieces on which there are ropes, cords, bands, cables, or wires containing
such materials.
• Make regular checks to ensure that the cutting disc is correctly fastened.
• Make sure that during the cutting operation, an adequate quantity of cooling water reaches the cutting
surfaces of the disc at all times.
• NEVER cut wood or metal with this saw.
• ALWAYS maintain sufficient distance from the cutting disc. Switch off the product and wait until the
cutting disc stops before removing workpieces, residual material, etc., from the work area.
• ALWAYS pull out the main plug (disconnect the product from its power supply) before commencing
work on the product.
• A cutting disc can cause injuries, even when stationary! Use protective gloves to change the cutting
disc.
• NEVER use lateral counter pressure to bring the cutting disc to a standstill after switching off the drive.
• Replace table insert when worn.
• Use only diamond discs recommended by the manufacturer.
• NEVER use blades on this machine.
• Use only diamond discs for which the maximum possible speed is not less than the maximum spindle
speed of the tool and the material to be cut.
• Maximum size of working piece should be 10 sq. ft. (1 m
• This tile saw should only be used at temperatures between 59°F - 80°F.
• USE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using
an extension cord, be sure to use one heavy enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage, resulting in loss of power and overheating. page 10
shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the gauge number, the heavier the cord.
STORAGE AND TRANSPORT
• ALWAYS store the product in a dry place.
• Store the product in a frost-free place.
• Protect the product from damage during transport.
• Keep the product away from children. Store the product in a place where it is safe from children and
unauthorized persons.
).
2
7
kobalttools.com
Publicidad
